Ausführliche technische Artikel, Materialvergleiche, Einblicke in die CNC-Bearbeitung und Problemlösungsleitfäden vom Ingenieurteam von Jucheng.
9. Oktober 2026
A wire EDM recast layer is material that melted during electrical discharge machining and then resolidified on the cut surface. It is not the same as surface roughness, and a…
Ganzen Artikel lesen
9. Oktober 2026
A finer wire EDM surface finish usually requires a different cutting strategy, not simply a promise to run the same…
8. Oktober 2026
Parting and grooving use narrow cutting edges, but they leave different responsibilities on a drawing. Grooving creates a recess that…
8. Oktober 2026
A poor turning surface finish is not always a feed-rate problem. Regular helical marks, torn patches, isolated scratches and broad…
8. Oktober 2026
A buyer may see “climb milling for a better finish” in a quote and assume the cutting direction is settled.…
8. Oktober 2026
A ring can measure round while the chuck is closed and fail roundness after it is released. In thin-wall turning,…
7. Oktober 2026
Milling chatter is a vibration problem in the complete cutting system, not a surface defect that a slower feed automatically…
7. Oktober 2026
A machined face can be flat and still lean relative to the mounting face that locates the part. Conversely, two…
7. Oktober 2026
A turned shaft can have every diameter inside its size limits and still make a bearing, seal, or coupling wobble.…
7. Oktober 2026
A deep pocket can look uncomplicated in a CAD view: an opening, four walls, and a floor. In the machine,…
