주성 엔지니어링 팀이 제공하는 심층 기술 기사, 소재 비교, CNC 가공 인사이트 및 문제 해결 가이드입니다.
10월 28, 2026
A robot tool plate can match its nominal hole pattern and still produce poor end-effector alignment. The critical relationship usually runs through more than the bolts: flange face, pilot or…
전체 글 읽기
10월 28, 2026
Robot gripper fingers can be dimensionally acceptable and still release, rotate, or mark a part. The cause is often a…
10월 28, 2026
Chatter marks on a turned part usually come from vibration in the tool–workpiece–machine loop, not from one bad cutting-speed setting…
10월 28, 2026
A useful inspection sampling plan starts by defining the lot, the characteristic being checked, how parts are selected, and what…
2026년 10월 27일
Built-up edge (BUE) is aluminum that adheres to a cutting edge instead of leaving cleanly with the chip. It can…
2026년 10월 27일
Chatter in surface grinding usually appears as a repeating pattern, waviness, or periodic finish variation, but the mark alone does…
2026년 10월 27일
A Swiss guide bushing supports bar close to the cutting zone, but its running fit must match the actual bar…
2026년 10월 27일
Cast and billet aluminum describe different stock histories, not a simple quality ranking. Cast stock begins as metal solidified in…
2026년 10월 26일
A CNC part that changes size during a run may be responding to thermal growth in the machine, the workpiece,…
2026년 10월 26일
Thread pitch diameter is the dimension that largely governs how external and internal thread flanks engage. A part can pass…
