In-depth technical articles, material comparisons, CNC machining insights, and problem-solving guides from the Jucheng engineering team.
October 21, 2026
A machined part can arrive at inspection still carrying heat from cutting, washing, or handling. Measuring it immediately may produce a result that changes as the part and the metrology…
Read Full Article
October 21, 2026
Cold-drawn steel often arrives with a smoother surface and closer starting dimensions than hot-finished stock, while annealed material may be…
October 20, 2026
A machined aluminum casting can look sound before the cut and reveal small cavities only after a face, bore, or…
October 20, 2026
Two blanks with the same aluminum alloy and temper can respond differently when a part is cut from different orientations…
October 20, 2026
A freshly dressed wheel can change both how a grinder cuts and where the finished size lands. Dressing restores or…
October 20, 2026
A dark line after grinding is a warning sign, not a complete inspection result. Some thermal damage is visible, while…
October 19, 2026
A facing cut that leaves a small center nub can point to a tool-height problem, but it does not prove…
October 19, 2026
A thin section can move during Wire EDM even though the wire never presses against it like a milling cutter.…
October 19, 2026
A spring pass repeats a finishing toolpath with no additional programmed depth of cut. It can help when the first…
October 19, 2026
Plunge milling is worth considering when a deep pocket, long tool overhang, or limited setup rigidity makes radial side cutting…
