In-depth technical articles, material comparisons, CNC machining insights, and problem-solving guides from the Jucheng engineering team.
9月 11, 2026
Before anyone sands an edge or adjusts an offset, keep one rejected part untouched. Its burr, fracture surface or free-state shape may be the best evidence available. Reworking every suspect…
Read Full Article
9月 11, 2026
A clear inspection window, a sliding guide and a hot electrical spacer do not need the same plastic. Starting each…
9月 11, 2026
A titanium bore measures correctly at the machine, then fails inspection. The next part needs another offset adjustment. A thin…
9月 10, 2026
Put a washdown housing, a dry locating block and a heavily loaded shaft on the same drawing-review table. All may…
9月 10, 2026
If a machined bracket bends too far, replacing 6061 with 7075 may barely change its deflection. If the bracket yields,…
9月 10, 2026
A lighter part is not automatically a better part. Neither is a stronger metal. In aluminum vs stainless steel CNC…
9月 9, 2026
The final few microns of a part can depend more on the precision grinding process than on the first machining…
9月 9, 2026
A reliable thread is a fit, alignment, chip-control, and inspection problem—not simply a hole with a spiral cut into it.…
9月 8, 2026
A hole is rarely just a diameter. CNC hole machining may need to control location, depth, straightness, finish, fit, threads,…
9月 8, 2026
Wire EDM process uses controlled electrical discharges rather than a conventional cutting edge to produce profiles in electrically conductive materials.…
