In-depth technical articles, material comparisons, CNC machining insights, and problem-solving guides from the Jucheng engineering team.
Сентябрь 11, 2026
A titanium bore measures correctly at the machine, then fails inspection. The next part needs another offset adjustment. A thin wall moves when the fixture opens. These observations may look…
Read Full Article
Сентябрь 10, 2026
Put a washdown housing, a dry locating block and a heavily loaded shaft on the same drawing-review table. All may…
Сентябрь 10, 2026
If a machined bracket bends too far, replacing 6061 with 7075 may barely change its deflection. If the bracket yields,…
Сентябрь 10, 2026
A lighter part is not automatically a better part. Neither is a stronger metal. In aluminum vs stainless steel CNC…
Сентябрь 9, 2026
The final few microns of a part can depend more on the precision grinding process than on the first machining…
Сентябрь 9, 2026
A reliable thread is a fit, alignment, chip-control, and inspection problem—not simply a hole with a spiral cut into it.…
Сентябрь 8, 2026
A hole is rarely just a diameter. CNC hole machining may need to control location, depth, straightness, finish, fit, threads,…
Сентябрь 8, 2026
Wire EDM process uses controlled electrical discharges rather than a conventional cutting edge to produce profiles in electrically conductive materials.…
Сентябрь 8, 2026
Small diameter does not automatically mean Swiss machining. The deciding issue is whether the part needs support close to the…
Сентябрь 7, 2026
A part can be rotational at its core and still be difficult to finish on a conventional lathe. Side holes,…
